.png?height=120&name=CPLogoRedNewWithDT%20(1).png)
This article will explain the process of getting your Ford switch installed on your truck.
1. Start by popping the hood on your truck and unpackaging your switch.
2. Locate the hood release cable where it is fed through the firewall.
3. Pull the hood release grommet out of the firewall under the hood.
4. Use a coat hanger or extra piece of wire to feed into the cab of the truck through the hood release cable hole in the firewall.
5. Inside the cab, locate the coat hanger/wire and tape switch wire ends to the end of your hanger/wire.
6. Pull the hanger/wire into the engine bay with the switch wires connected.
7. Untape the switch wires from the hanger/wire.
8. Using the supplied connector, pin switch wires into the connector. There are only 2 wires that need to be connected and they can go in either hole.
9. Once the switch has been pinned to the supplied connector, disconnect the factory harness from the fuel temp/pressure sensor.
10. Plug the new switch connector into the fuel temp/pressure sensor harness and then tape off the factory sensor to prevent corrosion.
11. Put a small slit in the hood release cable grommet to run your wire through and then reinstall the grommet.
12. Place conduit supplied with the switch over the wires to protect.
13. Find a spot inside the cab to mount your switch.
If you have any further questions or didn't find an answer to the question you had in this article, click here and fill out the form and one of our Remote Support experts will be in contact with you.