Roxor
      Back to home
      1. Help Center
      2. Switch Installation
      3. Roxor

      2018-2022 Roxor Tune Switch Installation Instructions

      This article will explain how to install your 5 position switch to switch tunes on your Roxor

      1. Start by feeding the 2 switch wires through the firewall of the vehicle into the engine bay.

      The 2 switch wires need to be fed through the firewall before being pinned into the connector supplied with the switch .


      2. Once you have fed the wire through the firewall you can then pin them into the supplied                   connector that came with the switch.  The 2 switch wires go to the 2 outermost pin positions           on the female connector.

      3. Next, unplug the factory wiring harness from the vacuum pump located on the driver-side               inner fender.

      4. Plug the male end of the switch connector into the vacuum pump, then plug the factory                     harness into the female end of the switch connector.

      5. Finally find a spot inside the vehicle to mount your switch.

       

      Below is a video showing the step-by-step process of installing the switch.

       

       

       

      If you have any further questions or didn't find an answer to the question you had in this article, click here and fill out the form and one of our Remote Support experts will be in contact with you.